Quikpoint
DESCRIPTION
Quikpoint is a lime and cement-based repointing mortar formulated to be used with a wide range of powered and manual grouting guns.
USES
For the Repointing of mortar joints in sandstone, brick, concrete and blockwork.
FEATURES
- Fast affective removal and replacement
- Assured mix ratios
- Reduced labour cost
- Available in a range of traditional colours
- Formulations for Heritage Buildings available
SURFACE PREPARATION
- Rake joints to a minimum of 20mm.
- All surfaces must be free of efflorescence, dust, dirt, oil, paint or other substances which may inhibit the adhesion of the mortar.
- Salt analysis and desalination may be required to increase the longevity of the mortar and protection of the building material. Refer to Westox Technical Department for more information on the Westox Cocoon Desalination System.
- Acid cleaned surfaces should be washed down with a neutralizing agent prior to application.
- Water blasted surfaces should be allowed to dry for a minimum of 24 hours before repointing.
- Mortar joint must be dampened before application.
MIXING
Each 20kg bag of Quikpoint will require approximately 4-5 litres of water to reach a gunable consistency. For wider joints a stiffer mix containing less water may be required.
CLEAN UP
Clean up all equipment with fresh water immediately after use.
PACKAGING
Quikpoint is supplied in a 20kg bag.
RESTRICTIONS
Do not apply during inclement weather.
Do not apply in temperatures exceeding 30ºC or below 5ºC
SAFETY
Refer to Westlegate Pty Ltd Material Safety Data Sheet (MSDS) for instructions.
APPLICATION EQUIPMENT
For all mortar removal and application equipment contact Quikpoint Pty Ltd on: Tel: (02) 8338 8914
Fax: (02) 8338 8915 Quikpoint is the registered trademark of Quikpoint Pty Ltd
Click here to view and print TDS
Click here to view and print MSDS